e.bloxx A6-2CF
CONFIGURATION
52
HB_EBLOXX-A62CF_E_V19.doc
Gantner Instruments Test & Measurement GmbH
Columns "Sensor", "Type of", "Connection", "Connection", "Terminals"
These columns are not relevant for the signal conditioning.
Column "Format/Adjustment"
The field shows the format, the unit, the number of digits and the position of the decimal point. The default format is
fff,fff.f without unit.
If in the column
“Additionals”
a reference to e.g. variable 1 is defined, the related format (unit, field length, precision)
will be used automatically. It is possible, to set the format, data type and direction as written in 5.4.1. In the case, that
the format will be changed, the automatic adaptation is not active. Is in the column
“Additionals”
the function minimum
or maximum selected, the button
Reset
is available.
Column "Range Error"
This column is not relevant for the signal conditioning.
Column "Additionals"
In this column the signal conditioning will be selected. As mentioned above there are the following functions available:
- Select unbalanced value: selunb
- Select gross value: selgro
- Select net value selnet
- Additional scaling scale
- Run/Hold hold
- Minimum store min
- Maximum store max
- Envelope function envel
- Special 1 … 4 spec1 … 4
- Constant const
• General Information to the Column
"Additionals"
The pop-up menu is designed like a calculator. The editing field on the top of the window shows the formula, that can be
created by using the variable buttons or by using the keyboard. The relevant variable is preset to that field. Below the
editing field the existing variables as buttons are available to use them to build the formula. The next field shows the list
of the digital I/Os that can be used in the formula. The field at the bottom offers the different functions like min, max or
hold.
To Next Page
Loading...
Need help?
General
