Need help?Do you have a question about the Gantner Q Series and is the answer not in the manual?
General| Brand | Gantner |
|---|---|
| Model | Q Series |
| Category | Control Unit |
| Language | English |
Product usage, personnel qualifications, and safety protocols.
High voltage risks, siting requirements, modification restrictions, and servicing procedures.
Explanation of hazard symbols, CE marking, module labels, and manual conventions.
Manual structure, system description, and module operation modes.
Steps for connecting modules to the base, power, and interface.
Connecting modules via Ethernet, RS-232, fieldbuses, and direct PC/PLC.
Methods for system synchronization and understanding module flashing indicators.
Overview of signal inputs, outputs, channel counts, and specific module examples.
Guide to installing test.commander, initial setup, and basic procedures.
Setting sensor parameters, scaling, calibration, and zero balancing.
Instructions for configuring digital inputs/outputs and analog outputs.
Setting up calculations, alarm conditions, and Test Controller system parameters.
Procedure for updating module and Test Controller firmware.
Using serial interfaces, converters, bus termination, and PC Ethernet setup.
Connecting sensors, scaling, current measurement, and thermocouple use.
Addresses and contact details for Gantner Instruments GmbH offices.
To Next Page
