Q.series
Gantner Instruments GmbH
3
Table of Contents
1 Safety Information ................................................ 9
1.1 Intended use .......................................................................... 9
1.2 Checking for damage in transit ............................................. 9
1.3 Personnel ............................................................................... 9
1.4 Special risks......................................................................... 10
1.5 Siting locations .................................................................... 10
1.6 Modifications........................................................................ 10
1.7 Servicing and cleaning......................................................... 10
1.8 Disposal................................................................................ 11
1.9 General hazards due to non-observance of the safety
information........................................................................... 11
2 Labels and warning information......................... 13
2.1 Warning information ............................................................ 13
2.2 Labels on the modules ......................................................... 13
2.3 Labels in this manual ........................................................... 14
3 Introduction ........................................................ 15
3.1 The documentation in the Q.bloxx range............................. 16
3.2 About this manual ................................................................ 16
3.3 System description............................................................... 17
3.3.1 Operating the modules via Q.gate........................................ 17
3.3.2 Operating the modules via Q.pac ......................................... 19
3.3.3 Operating the modules without Test Controller................... 20
4 Connecting the modules ..................................... 21
4.1 Connecting the base ............................................................ 21
4.1.1 Hot swap (factory setting) .................................................... 22
4.1.2 Setting the address (optional) .............................................. 23
4.1.3 Activating the terminating resistances ................................ 24
4.1.4 Mounting/removing bases .................................................... 25
4.1.5 Q.bloxx Extension Socket QES ............................................. 26
4.2 Connecting the power supply .............................................. 28
4.3 Fitting and removal of modules from bases......................... 30
4.4 Connecting interfaces .......................................................... 31
4.4.1 Connecting modules to Q.gate ............................................. 31
4.4.2 Connecting modules to Q.pac............................................... 32
4.4.3 Connecting Q.gate/Q.pac via Ethernet to a PC/PLC............. 34
To Next Page
Loading...
Need help?
General
