Q.series
Gantner Instruments GmbH
11
1 Safety Information
• Before cleaning, disconnect all connectors.
• Clean the housing with a soft, slightly moistened cloth. Never
use any solvents, because these may attac
k the labels.
• When cleaning, make sure that no liqui
d enters into the
device or goes onto the terminals.
Never attempt to repair nor to again op
erate devices which are
defective, have developed a fault or are damaged. In this case it
is essential to contact your customer consultant or Gantner
Instruments GmbH.
1.8 Disposal
Old devices which are no longer usable must be disposed of
according to national and local regulations regarding environ-
mental protection and raw-material recycling. Electronic compo-
nents must not be disposed of with the household refuse. The
packaging can be recycled and shoul
d therefore be passed into
the recycling system. However, we recommend that the packag-
ing is kept until the end of the warranty period so that you can
pack faul
ty devices or modules properly.
1.9 General hazards due to non-observance of the
safety information
The modules or devices conform to the state of the art and are
operationally safe. However residual risks may arise when they
are used and operated improperly by untrained personnel.
Any person commissioned with the task o
f
siting, operating, ser-
vicing or repairing a module or device in the Q.series must have
read
and understood the operating manual and in particular the
information relating to safety.
To Next Page
Loading...
Need help?
General
