Vers. No. 6.1
38 Released: 25/04/2017
4 Connecting the modules → Synchronization of several systems
2. Start the software and select the Utilities > Module setup
assistant
Another program window opens.
3. Select Options > Comm
unication settings.
4. Under Interface type select
the RS-232 direct connection
and under ComPort the PC connection you are using.
5. Close the dialog with OK.
Further interface parameters are not needed.
6. Click on Find modules.
The program searches the specified interface for connected
modules a
nd displays all the modules found in the program
window. If there are addressing conflicts, they are also dis-
played. Specify unique addresses for the mod
ules; refer to
Section 5.2 on page 103.
4.4.5.2 Establishing connection with ICP 100
1. Make sure that the current version of the ICP 100 software is
installed on your PC.
You will find the current version in the download section of
our home page. If necessary, in
stall the current version; refer
to Section 5.1 on page 102.
2. Start the software and select Communica
tion > Parame-
ters.
3. Under Interface type select
the RS-232 direct connection
and under ComPort the PC connection you are using.
4. Close the dialog with OK.
The program searches the specified interface for connected
modules a
nd displays all the modules found in the program
window. If there are addressing conflicts, they are also dis-
played. Specify unique addresses for the mod
ules; refer to
Section 5.2 on page 103.
4.5 Synchronization of several systems
The synchronization of several interconnected Q.bloxx modules is
ensured by the Test Controller. Both Q.gate and Q.pac ensure
that all slave modules operate synchronously with the maximum
jitter being approx. ±2 μs over all modules.
Yo
u have various methods of obtaining synchr
onization, even
with several systems (refer also to Fig. 4-13 on page 40):
To Next Page
Loading...
Need help?
General
