Q.series
Gantner Instruments GmbH
9
1 Safety Information
1 Safety Information
Before starting installation, setting up, operation and before
maintenance work is carried out, it is essential to read and follow
the appropriate warning and safety information given in this
manual.
Installation, setting up
, op
eration and maintenance of the mod-
ules or devices must take place as intende
d, i.e. under the condi-
tions of use laid down in this manual and in the te
chnical data for
the relevant module or device.
1.1 Intended use
The products in the Q.series range are intended for use in indus-
trial and experimental test engineering and for monitoring
assembly an
d production processes. Transducers (sensors) for
the acquisition of physical quantities such as voltage, current,
resistance, temperature, force, displacement, torque, mass,
strain and pressure can be connected. The modules are used
exclusively for these kinds of measurement and control applica-
tions. Any application which goes beyond this scope does not fa
ll
within the intended use of the modules.
To ensure safe operation the modules and
devices must only be
operated according to the details given in the manuals and tech-
nical data sheets. In addition, the required legal and safety regu-
lations covering the respective application must
be followed. This
applies in particular to the modules A123, A124, A127 and A128
with which input voltages of up to 1200 V
DC
are possible.
1.2 Checking for damage in transit
On receipt of the goods visually check that the packaging and the
module or device together with the data medium are intact. Also
check the shipment for completeness (accessory parts, documen-
tation, auxiliary aids, etc.). If the packaging ha
s been damaged in
transit or if you suspect that the product is damaged or may mal-
function, the product must not be put into operation. In this case
contac
t your customer consultant or Gantner Instruments GmbH.
1.3 Personnel
The installation, operation and maintenance of the modules or
devices must only be carried out by competent persons. Compe-
tent persons are those who through their
professional education
have sufficient knowledge in the required field and are familiar
with the relevant national occupational protection regulations,
To Next Page
Loading...
Need help?
General
