Gantner e Series - Page 59

e.bloxx A6-2CF
CONFIGURATION
HB_EBLOXX-A62CF_E_V19.doc 57
Gantner Instruments Test & Measurement GmbH
Combination of the Conditioning Functions
The signal conditioning functions can be used once per function, parallel and in combinations. The following diagram
shows the principle.
Cross or net to set variable, e.g. net to variable 2
Output to connect to any input, e.g. net value to scaling
Input to connect any output, e.g. maximum and minimum from scaling
Example: The net value of pressing force has to be measured and its maximum should be stored. The actual force
value should be displayed in Newton and in pounds. The unbalanced value should be controlled too, to avoid
an overloading of the sensor.
Block Diagram:
Tarring Maximum
Scaling
Sensor
Input
Maximum net [kN]
Force [lbf]
Force [kN]
Unbalanced value [kN]
Variable 1
analog input
function
zero balance
function
tare balance
Unbalanced value
Cross value
Net value
function
scaling
function
minimum
function
maximum
function
run/hold
Variable 2
Set variable
Variable 2...
Set variable
function
envelope