32
Event Source Configuration
To configure the event sources, click the Event Source tab.
Sensor (DI)
Select the Enable sensor check box to enable DI as the event source. There is a hyperlink to
access the DI/DO configuration page.
Motion detection
Select the Enable motion detection check box to enable motion detection as the event source.
Selecting the check box displays the motion detection options as shown above. Set the time
for motion interval from 0 to 100 seconds to avoid continuous triggered MD events. Finally
select the motion detection zones to use as the event source from the list. There is also a
hyperlink to access the motion detection configuration page.
VCA source
Select the VCA events that are to be notified. Available options may differ by purchased
analysis options. There is also a hyperlink to access the VCA configuration page
Network setting changed
This option allows the user to receive events when network setting is changed.
Fan/Heater operation changed
This option allows the user to receive events when operation of fan and heater is changed.
Event Notification Configuration
To Next Page
Loading...