Strike Test
The Strike Test feature is a function of the WX500. For
details about using this feature refer to the WX500
owner’s documents.
The Strike Test feature is used by installers to verify
proper operation of the WX500. Test strikes are sent to
the antenna. The received test strike is then visually
presented on the screen.
Antenna Change Message
When an “Antenna Change” message is shown, the
lightning sensor may have failed. When this message is
displayed, the sensor is automatically shut down for the
remainder of the flight. The installation should be
inspected before the lightning function is used again.
85
Detailed Operation
To Next Page
Loading...
