GarrettCom DynaStar DS2000-TS - Page 78

A
PPENDIX
B -
Network Commands
Router (IP)
DS2000-TS Administrator’s Guide
B - 8
Use the IP Filter Table to specify up to 60 specific filtering actions and also to designate a default IP action
for frames not matching any filter specification. The IP Filter process searches from the top of the table
(after a sort process described below) and performs a filtering action based on the first match that it finds for
an address. If no match is found for either the source or destination address, the call is blocked or forwarded
based on the selection in the Default filter action field. This field is initially configured to forward all
traffic.
Figure B-7. IP Filter Table Menu
B.2.4.1 To Configure IP Filtering
First, place the cursor in the Type column and press <Enter> to select the desired type of filter being
defined on that line of the filter table:
• Both filters on both the source and destination addresses configured
• Src (Source) filters on only the specific IP source address configured
• Dest (Destination) filters on only the specific IP destination address configured
• NetB (Netboth) filters both the source and destination network addresses based on the
masks entered on the same line
• NetS (Netsource) filters the source network address based on the mask entered on the same
line
• NetD (Netdest) filters the destination network address based on the mask entered on the
same line
Next, tab to the Source IP, Destination IP, and/or Mask fields as appropriate and enter a complete address
or mask as required for the type of filtering you are configuring.
•
The VPN field has reserved meaning and is not utilized at this time.
The Protocol Filter column entry is changed by pressing <CTRL-O> and toggling the Action field to
Block or Forward.
To set protocol-specific filters or to change the Default action from forward to block, enter <CTRL-O> to
access the optional UDP/TCP Filter Table screen shown in Figure B-8.
*** IP Filter Table ***
Last changed: 7-14-04 12:33:29
Type Source IP Mask Destination IP Mask VPN Protocol Filter
(Tog) (Address) (Bits) (Address) (Bits) (Tog) Ctrl O to configur
1 Forward
__________[DynaStar_24]___________ Process selections (Y/N): Y
Use <CTRL-D> to delete entry Use <TAB> and CURSOR to move fields
Press ESC to return to previous menu Press <CTRL-O> for more options