Gateway E-Series User Manual

www.gateway.com
87
Diskette drive
The diskette drive is not recognized
• Shut down and restart your computer.
You cannot save a file to diskette or you see the message
“disk is full or write-protected”
• Make sure that the write-protection tab on the
upper-right corner of the diskette is down (unprotected).
• The diskette may be full. Delete unnecessary files on the
diskette and try again.
• Make sure that the diskette you are using is
IBM-compatible.
• Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
• Run Error-checking on the diskette. For more
information, see “Checking the hard drive for errors” on
page 78. If errors are detected and corrected, try using
the diskette again.
You see an “Access Denied” or “Write protect” error
message
• Make sure that the write-protection tab on the
upper-right corner of the diskette is down (unprotected).
• The diskette may be full. Delete unnecessary files on the
diskette and try again.
• Make sure that the diskette you are using is
IBM-compatible.
• Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
You see a “Disk is full” error message
• Delete unnecessary files on the diskette.
• Try a different diskette. Occasionally diskettes are flawed
and cannot be read by the diskette drive.
• Run Error-checking on the diskette. For more
information, see “Checking the hard drive for errors” on
page 78. If errors are detected and corrected, try using
the diskette again.
You see a “Non-system disk” or “Disk error” error message
• Eject the diskette from the diskette drive, then press
E
NTER.
• Make sure that the diskette you are using is
IBM-compatible.
8512732.book Page 87 Thursday, September 27, 2007 11:33 AM

Gateway E-Series Specifications

General

Brand	Gateway
Model	E-Series
Category	Desktop
Language	English