GCC Technologies RX Series - Page 55

RX Series User Manual
The Control Panel 3-10
4. Press [UP ARROW /DOWN ARROW] to change the
values of the actual length.
Scale Width
Scale Length
Fixed scaling, for maintenance only.
MAC Address
Shows the MAC Address of your cutting plotter.
IP Address Shows the IP Address of your cutting plotter.
DHCP
Shows your IP address for TCP/IP Configuration
Disable
Select Units Provide four-unit systems for users convenient. cm/gram; inch/oz;
cm/oz; inch/gram
Metric
Select
Language
To select displayed languages on LCM panel in English,
Spanish, Italian, Deutsch, Japanese, Portuguese, Polish,
Turkish
or
French
.
English
Sizing Setting
Allows user to set the sizing settings.
If set to user defined mode, the user will be asked to select the
size setting every time the machine is turned on.
If set to Default Roll, Roll type sizing will be performed
whenever the machine is turned on.
User Defined
/Default Roll
User
Defined
Firmware
Version
To display the version number of Firmware and FPGA code,
varying from model to model
Set
Communication
To build up the communication between host computer and
cutter.
Baud Rate is to determine the speed of data transmission.
Data Bits refers to the size of one block of data.
Parity is used to check if data was revived correctly or not.
9600, n, 7, 1, p 9600pbs, 7 Bits with NO Parity
9600, o, 7, 1, p 9600pbs, 7 Bits with ODD Parity
9600, e, 7, 1, p 9600pbs, 7 Bits with EVEN Parity
9600, n, 8, 1, p 9600pbs, 8 Bits with NO Parity
9600, o, 8, 1, p 9600pbs, 8 Bits with ODD Parity
9600, e, 8, 1, p 9600pbs, 8 Bits with EVEN Parity
19200, n, 7, 1, p 19200pbs, 7 Bits with NO Parity
19200, o, 7, 1, p 19200pbs, 7 Bits with ODD Parity
19200, e, 7, 1, p 19200pbs, 7 Bits with EVEN Parity
19200, n, 8, 1, p 19200pbs, 8 Bits with NO Parity
19200, o, 8, 1, p 19200pbs, 8 Bits with ODD Parity
19200, e, 8, 1, p 19200pbs, 8 Bits with EVEN Parity
Paper Saving
Mode
To save media by four different modes:
1. Length expanded mode 2. Width expanded mode
3. Both expanded mode 4. Both unexpanded mode
Length
expande
d mode
AAS Offset To set or modify AAS offset value.
You can refer to “5.3 Printer Test” for more details.
First Back to
Origin
To enable the carriage back to the previous origin; when
“Enable” is selected, the carriage will not go back to the
previous origin while the selection of “Disable” allows the
carriage to do so.
Enable
Disable
Enable
Vacuum To help improve tracking and cutting accuracy by turning on
the fans. If you turn off the vacuum system, the fans
will remain inactive during cutting or plotting.
Enable, Disable Enable
Auto Unrolled
Length
To adjust the unrolled media length. 500-3000 mm 500 mm
[ CUT OFF ]
To cut off the material automatically when the job is complete
d,