Chapter 3. Programming
34 PanaFlow™ LC User’s Manual
3.1.2 Indicator Lights
• The blue light on the top right above the display is the Power Indicator that is normally lit when the
instrument is powered.
• The red light on the top left above the display is the Error Indicator. The Error Indicator light blinks if
an instrument error is detected. A short error message will be displayed in the lower left-hand corner
of the Measurement View. If the instrument is operating without error, red light is turned OFF.
3.2 Passcodes
IMPORTANT: Not all users will have access to all of the menus. Some menus are restricted to only those users
with the proper passcodes.
The default passcodes for the XMT1000 flow transmitter are:
• Keypad Lockout Password, default (fixed) = 102719 [this password cannot be changed]
• Operator Password, default (changeable) = 111111
• Software Upgrade Password, System Generated specific for the System Serial Number [this password
cannot be changed].
IMPORTANT: BHGE recommends changing all default (changeable) passwords after commissioning the meter.
3.2.1 Unlock from Keypad Lockout
After power up, if the meter’s Measurement View (Refer Figure 48) shows a lock icon on the top right of the
display, use the following steps to unlock the meter from keypad lockout mode.
• Press ESC-ENT-ESC [ ] followed by either “Operator” password or the “Keypad Lockout”
password. The lock icon on the top right of the display will show an open lock indicating the meter
keypad is unlocked.
3.3 Measurement View, Log-in and Primary Pages
3.3.1 Measurement View
On power up, the XMT1000 meter shows the following screens:
• Panametrics Logo screen
• Meter Initialization screens
• Power-on self-tests and results
Up Arrow Key To navigate among menu choices, pages or increase/decrease
numeric entries
Down Arrow Key To navigate among menu choices, pages or increase/decrease
numeric entries
Key Symbol Key Name Functions
To Next Page
Loading...
