GE Baker Hughes PanaFlow LC XMT1000 - 3.5.4 Option Comm Slot-1 (optional)

Chapter 3. Programming
54 PanaFlow™ LC User’s Manual
3.5.4 Option Comm Slot-1 (optional)
3.5.4a Option Slot-1 Configured as HART
Use steps as in section “Log-in and Primary Pages” to navigate to the Input/Output settings page.
1. Then highlight [Option Comm (Slot 1)] and press [ENTER]. Then highlight [HART] and press [ENTER].
2. You can set Analog Output with HART option. Refer to Figure 61 and Figure 57.
3. You can also view the HART hardware and software revision numbers in About HART option.
Figure 61: Option Slot-1 Configured as HART
3.5.4b Option Slot-1 Configured as FF
Use steps as in section “Log-in and Primary Pages” to navigate to the Input/Output settings page.
1. Highlight [Option Comm (Slot 1)] and press [ENTER]. Then highlight [FF] and press [ENTER].
2. You can view the FF hardware and software revision numbers in About FF option.
Figure 62: Option Slot-1 Configured as FF
HART
Measurement Type
Volumetric (Std)
Velocity
Mass
Full Value
Full Value
Analog Output
Calibrate
Base Value
Error Handling
10 ft^3/s
Full Value
Input/Output
Analog Output (Std)
Option Comm (Slot 1)
About HART
Analog Output
Base Value
Full Value
Calibrate
Measurement Type
Value
UNIT: mA
4.00
Calibrate
Calibrate 4mA
Calibrate 20mA
Analog Output
Calibrate
Base Value
Error Handling
Full Value
Analog Output
Calibrate
Base Value
Error Handling
Full Value
Error Handling
HART
About HART
HW Revision 0.1.0.0
HART
Error Handling Value
Value
4.00 mA
SW Revision 0.0.0.1
Volumetric (Act)
Full Value
UNIT: ft^3/s
10
Calibrate 4mA
UNIT: mA
4.000
Percentage of Scale
Hold
Low
High
Other
Analog Output
About HART
Analog Output
Option Comm (Slot 1)
9
2
9
2
9
2
9
2
9
2
9
2
9
2
9
2
or
9
2
9
or
9
2
9
or
9
2
9
or
9
2
9
Digital Output (Std)
Option I/O (Slot 2)
[ ]
2
9
[ ]
UNDO
MOVE
[ ]
[ ]
SAVE
ALTER
[ ]
2
9
[ ]
UNDO
MOVE
[ ]
[ ]
SAVE
ALTER
[ ]
2
9
[ ]
UNDO
MOVE
[ ]
[ ]
SAVE
ALTER
Operator Access or Higher
Input/Output
Analog Output (Std)
Option Comm (Slot 1)
FF
9
2
Option Comm (Slot 1)
2
About FF
9
FF Board
9
Option I/O (Slot 2)
About FF
SW Revision 0.0.2.1
HW Revision 0.1.2.0
2
Digital Output (Std)
Operator Access or Higher