5.1 Overview
The typical workflow for performing a run in Biacore X100 is shown in the table below.
Some analyses may require several runs to complete the experiment.
More informationDescriptionStage
Biacore X100 Handbook or software
support
Create a workflow or wizard template,
or use a previously saved workflow.
1
Section 5.3 Preparing, loading and
changing buffers, on page 53 and
Section 5.6 Preparing and loading
samples and reagents, on page 57
Prepare buffer and samples.2
Section 5.7 Starting a run, on page 59Start the run.3
Section 5.8 Post-run procedures, on
page 60
Finish the run.4
Biacore X100 Handbook or software
support
Evaluate the results.5
Biacore X100 Operating Instructions 28961142 AD 49
5 Operation
5.1 Overview
To Next Page
Loading...
