5.2 Starting the instrument
Introduction
This section describes how to start the instrument from shutdown or from standby mode.
Start the instrument from
shutdown
NOTICE
If you have the Biacore X100 Plus Package, always keep the buffer
tubes in liquid when the instrument is powered on to prolong the
life of the degasser.
Follow the steps below to start the system from shutdown.
ActionStep
Switch on the printer and the PC.1
Open the lower front door on the instrument and close the cover of the
peristaltic pump. Close the door before continuing.
2
Switch on the instrument (see Connections, on page 35). The status indicators
on the front panel light during initiation (see Status indicators, on page 36).
When the initiation is ready, Power is lit, the Temperature lamp is lit or
flashes, Sensor chip is not lit or flashes and Run is not lit.
3
Start Biacore X100 Control Software.4
50 Biacore X100 Operating Instructions 28961142 AD
5 Operation
5.2 Starting the instrument
To Next Page
Loading...
