GE Druck ADTS 405 - SETUP, LEAK MEASURE CONTROL, [AUTO LEAK]; SETUP, LEAK MEASURE CONTROL, [AUTO LIMIT]; SETUP, EXECUTE TEST PROGRAM

K114 Issue No. 9
Reference and Specification
6 - 24
SETUP, LEAK MEASURE CONTROL, [AUTO LEAK]
 This function enables or disables the auto leak recovery facility.
See LEAK MEASURE/CONTROL for further details.
SETUP, LEAK MEASURE CONTROL, [AUTO LIMIT]
 This function enables or disables the auto limit recovery facility.
See LEAK MEASURE/CONTROL for further details.
SETUP, GROUND
 This function enables the station (airfield) altitude to be entered and is used when
displaying QNH. See GROUND for further details.
 Enter the station (airfield) altitude in the units shown on the display.
See CONFIG, [UNITS], [AERONAUTICAL] for default units.
SETUP, PORT
 This function sets up the port option.
 If an option, that is not fitted, is selected the display shows the error message "Option
Hardware not fitted". Refer to the Line Switching Unit, User Manual.
SETUP, PRINT, [DATE/TIME]
 This function allows the system time and date to be set. The time and date is
maintained by a battery-backed clock when the ADTS 405 is switched off.
 Use [TIME] or [DATE] to select between time or date.
 To change the time or date, enter all six digits and press ENTER.
 The date format can be either US (mm/dd/yy) or UK (dd/mm/yy) using CONFIG,[MORE],
[DATE FORMAT]. The time format is hh:mm:ss.
SETUP, EXECUTE TEST PROGRAM
 This function sets up the results file options.
 Result data generated by the test program can either be sent out to the printer port or
saved to a result file and stored in the ADTS 405. Pressing F1, the [PRINT/SAVE] key,
sets the option.
 Any of the results files, stored in the ADTS 405, can be sent to the printer port. Press F2,
the [PRINT FILE] key, to select the required file.