K114 Issue No. 9
Druck ADTS 405 User Manual 3 - 17
3
3.10 Rate Timer Displays (Fig 3.7 and Fig 3.8)
When in Leak Measure mode and, after completing a rate timing, the system generates
the rate timer displays. These displays do not depend on the display mode (single,
dual, triple or option). Pressing a parameter key (ALT, ROC, etc.,) or CLEAR/QUIT exits
the rate timer displays.
FIGURE 3-7 RATE TIMER DISPLAY AERONAUTICAL UNITS
FIGURE 3-8 RATE TIMER DISPLAY PRESSURE UNITS
Note: There is no pointer for the primary parameter, values cannot be entered in
the rate timer displays.
To Next Page
Loading...
