K114 Issue No. 9
4 - 4
Maintenance
4.4 Routine Maintenance
WARNING:
S
WITCH OFF AND DISCONNECT THE POWER SUPPLY BEFORE STARTING ANY MAINTENANCE TASK.
Carrying out the maintenance tasks detailed 4.3.
Servicing Procedures
The following procedures provide instructions to test and replace items for the operator.
Return the unit to the intermediate service depot for further testing and replacement of items.
Replacing the output connector o-ring
After inspection as detailed in maintenance task B, carry out the following if the o-ring is
worn or damaged:
Carefully remove the o-ring from the small groove
at the top of the connector.
Fit a new o-ring in the small groove at the top of
the connector.
Make sure the o-ring is tight in the groove and not
damaged after fitting.
Note: Damage to this o-ring causes leaks.
To Next Page
Loading...
