K114 Issue No. 9
3 - 18 Operation
3.11 Pt Only Display (Fig 3.8)
The Pt only display overrides the other display modes (single, dual and triple). The
measured altitude and the CAS are produced from Ps in measure mode.
FIGURE 3-9 PT ONLY DISPLAY
3.12 Changing the Display
The display can show either one, two or three parameters as follows:
Note: Display cannot be changed with SETUP switched off or in minimum mode.
To change the display:
Press SETUP.
Select [MORE].
Select [DISPLAYS/OPTIONS].
Select [DISPLAY TYPE].
Using [NEXT] or [PREV].
Select either SINGLE, DUAL or TRIPLE, ARINC, ENCODER
(more display types with options fitted).
Press [SAVE] to accept.
Press CLEAR/QUIT repeatedly to return to user display.
To change the display for Pt Only:
Press SETUP.
Select [MORE].
Select [Control], [Ps Pt Dual].
Select [Pt Only Mode].
Press CLEAR/QUIT repeatedly to return to user display.
To Next Page
Loading...
