After the Exam is Over
3-34
LOGIQ E9
–
User Guide
Direction 5454884-100 English
Rev. 1
Restore procedure: user-defined configurations
1. Insert the media with the user-defined configurations into
the drive.
2. On the Touch Panel, press Utility.
3. On the Utility Touch Panel, press System.
4. On the monitor display, select Backup/Restore.
The Backup/Restore screen is displayed.
NOTE: If you are not logged in with administrator privileges, the
Operator Login window is displayed. Log on with
administrator privileges.
5. In the Restore list, select from the following, depending on
which configurations you want to restore:
• User Defined Configuration
OR
• Select the parameters to be restored in the Detailed
Restore section.
6. In the Media field, select the media.
7. Select Restore.
The system performs the restore. As it proceeds, status
information is displayed on the System/Backup/Restore
screen.
The restore procedure overwrites the existing database on the
local hard drive. Make sure to insert the correct media.
To avoid the risk of overwriting the local patient and report
archives, DO NOT check Patient Archive when restoring
user-defined configurations.
To Next Page
Loading...
