Performing an Exam
2-10
LOGIQ E9
–
User Guide
Direction 5454884-100 English
Rev. 1
3D Mode
Acquiring a 3D Scan
To acquire a 3D scan,
1. Optimize the B-Mode image. Ensure even gel coverage.
2. Press the 3D control panel key. Two screens appear.
NOTE: Set appropriate values for Acq Mode and Scan Plane. Also,
set the scan distance before scanning.
3. To start acquiring the image, press Start (Trackball key).
4. To perform a parallel scan, scan evenly. To perform a sweep
(fan) scan, rock the probe once. Note the distance of the
scan.
5. The 3D volume of interest (VOI) is dynamically assembled
on the right side of the screen.
NOTE: If the image stops before you’re done scanning, start
acquiring the 3D volume of interest again.
6. To complete the 3D scan, press End (Trackball key).
NOTE: You can also press Freeze, but then you need to also press
the 3D key to obtain the final render.
Table 2-5: 3D Package Options
3D Type Description Sensor/No Sensor Available Tabs
Easy 3D Designed for rendering
B Mode and Color Flow
Mode images, e.g.,
Baby Face scans.
No sensor 3D Acquisition, Easy
3D, Movie
Advanced 3D Designed for rendering
B Mode and Color Flow
Mode images, e.g.,
vessel trees.
No sensor 3D Acquisition, Easy
3D, Advanced 3D,
Movie
Tru3D (Option) Designed for rendering
B Mode and Color Flow
Mode images, e.g.,
vessel trees.
Sensor 3D Acquisition, Easy
3D, Advanced 3D,
Movie, Tru3D
To Next Page
Loading...
Need help?
General
