Safety Precautions
LOGIQ E9
–
User Guide
4-19
Direction 5454884-100 English
Rev. 1
EMC (Electromagnetic Compatibility)
NOTE: This equipment generates, uses and can radiate radio
frequency energy. The equipment may cause radio frequency
interference to other medical and non-medical devices and radio
communications. To provide reasonable protection against such
interference, this product complies with emissions limits for a
Group 1, Class A Medical Devices Directive as stated in EN
60601-1-2. However, there is no guarantee that interference will
not occur in a particular installation.
NOTE: If this equipment is found to cause interference (which may be
determined by turning the equipment on and off), the user (or
qualified service personnel) should attempt to correct the
problem by one or more of the following measure(s):
• reorient or relocate the affected device(s)
• increase the separation between the equipment and the
affected device
• power the equipment from a source different from that of the
affected device
• consult the point of purchase or service representative for
further suggestions.
NOTE: The manufacturer is not responsible for any interference caused
by using other than recommended interconnect cables or by
unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the users’
authority to operate the equipment.
NOTE: To comply with the regulations on electromagnetic interference
for a Class A FCC Device, all interconnect cables to peripheral
devices must be shielded and properly grounded. Use of cables
not properly shielded and grounded may result in the equipment
causing radio frequency interference in violation of the FCC
regulations.
To Next Page
Loading...
Need help?
General
