GE LOGIQ E9

After the Exam is Over
3-58 LOGIQ E9 – User Guide
Direction 5454884-100 English
Rev. 1
Cleaning the system
Prior to cleaning any part of the system:
1. Turn off the system power. If possible, disconnect the power
cord. See ‘Power Off’ on page 1-25 for more information.
System Cabinet
To clean the system cabinet:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
NOTE: The cloth should be damp, not dripping wet.
2. Wipe down the top, front, back, and both sides of the system
cabinet.
3. Wipe off excess cleaning agents.
NOTE: Do not spray any liquid directly into the unit.
Other acceptable cleaning agents are:
• Ammonia
• Bleach (10 to 1 ratio of 5% home bleach)
• Hydrogen Peroxide / Hydrogen Peroxide Wipes
Touch Panel
To clean the Touch Panel:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
NOTE: The cloth should be damp, not dripping wet.
2. Wipe down the top, front, back, and both sides of the Touch
Panel.
3. Wipe off excess cleaning agents.