GE LOGIQ E9 User Guide

Probes
LOGIQ E9 – User Guide 1-31
Direction 5454884-100 English Rev. 1
Disconnecting the Probe
Probes can be disconnected at any time. However, the probe
should not be active when disconnecting the probe.
1. Ensure the probe is deactivated. Deactivate by selecting
another probe or pressing Freeze.
2. Move the probe locking handle to the left.
3. Pull the probe connector straight out of the probe port
carefully.
4. Carefully slide the probe and connector away from the
probe port and around the right side of the keyboard.
5. Ensure the cable is free.
6. Be sure that the probe head is clean before placing the
probe in its storage box or wall hanging unit.
7.
Probe Discussion
The LOGIQ E9 supports the following types of probes:
• Matrix Array. Matrix Array probes.
• Convex Array. Convex Array probes.
• Linear Array. Linear Array probes.
• Micro Convex Array. Micro Convex Array probes.
• Sector Phased Array. Sector Phased Array probes.
• Volume Probes. 4D probes: Convex Array, Micro Convex
Array, Linear Array.
CAUTION
Probes for transvaginal and transrectal applications require
special handling. Transvaginal/transrectal examinations and
probe insertions should be performed only by personnel with
adequate training. Refer to the user documentation enclosed
with these probes.

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor