GE LOGIQ E9 User Guide

Getting Started
1-66 LOGIQ E9 – User Guide
Direction 5454884-100 English
Rev. 1
Beginning an Exam
Scanning a New Patient
1. Press Patient.
2. Press New Patient on the Patient menu.
3. If there are images on the clipboard, a pop-up menu
appears. Specify whether you want to store images
permanently, delete images, or go to active images.
4. Choose the exam category.
5. Verify the dataflow.
NOTE: DO NOT use the removable media Dataflows on the New
Patient menu.
NOTE: The system can display a warning dialog when the patient is
registered to “No Archive”. If the “Warn register to No
Archive” preset is selected in the Utility -> Connectivity ->
Miscellaneous menu, a warning displays. A different
dataflow for permanent storage of patient data should be
selected.
6. Fill in patient information.
NOTE: You can also select a patient from the patient database at
the bottom of the Patient menu if the patient has a patient
ID.
Columns drive the ordering of the patients displayed. The
column that you select drives the order of the displayed
patient database.
NOTE: Do not use the following characters when filling in patient
information:
“ ‘ \ / : ; . , * < > | + = [ ] &
7. Select Register.
8. Select the probe to start scanning (or select Exit, Esc, Scan,
or Freeze).
9. Perform the exam.

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor