Getting Started
1-60
LOGIQ E9
–
User Guide
Direction 5454884-100 English
Rev. 1
4D Biopsy Guide Assembly - Representative Example
4D Probe
Figure 1-42. Mounting the Biopsy Needle Guide to the 4D
Probe
1. Place the needle guide onto the probe.
2. Push the needle forward until the bracket catches in the
support on the housing of the probe.
3. Fix the biopsy guide by locking the frame on the opposite
side.
4. Pull lightly and rotate the needle guide barrel to position with
the needle hole on the front side.
NOTE: Needle guide sterilization with autoclave possible.
4D Endocavitary Probe
1. Press the needle guide onto the probe shaft and push it
forward until the small swelling of the needle guide cacthes
in the notch at the probe tip.
NOTE: Material: Stainless Steel
NOTE: Needle guide sterilization with autoclave possible.
To Next Page
Loading...
