Performing an Exam
2-12
LOGIQ E9
–
User Guide
Direction 5454884-100 English
Rev. 1
Split Screen
To activate a dual split screen, press L or R.To activate a quad
display, press and hold down L.
When you activate Split Screen by pressing L, the single image
is placed on the left side; when you activate Split screen by
pressing R, the single image is placed on the right side.
To switch between active images, press L/R.
To deactivate, press R until the screen changes.
Dual Caliper
In split screen, you can draw a caliper, area, ellipse, or spline
trace on both the left and right image at the same time.
Whichever side of the screen that you annotate is called the
“Original” graphic. The copy is called the “Shadow” graphic.
Freezing an image
To freeze an image,
1. Press Freeze. The Freeze key backlight turns green.
If you are in a mixed mode, both screen formats stop
immediately. Deactivating Freeze restarts both modes and
places a black bar on the trace to indicate the time discontinuity.
To reactivate the image,
1. Press Freeze again.
NOTE: Deactivating Freeze erases all measurements and calculations
from the display (but not from the worksheet).
Use the Trackball to start CINE after pressing Freeze.
Activating CINE
To activate CINE,
1. Press Freeze.
2. Move the Trackball.
To Next Page
Loading...
