GE LOGIQ P6 Service Manual

GE HEALTHCARE
DIRECTION 5245279, REVISION 3 LOGIQ™ P6/P6 PRO SERVICE MANUAL
Section 8-4 - Software Installation 8 - 129
8-4-4-3 Setting Printer Preferences (cont’d)
8.) Click the properties of the Density Adjust".
9.) Click "Load".
10.)Select removable disk or media which the printer setting was saved -> click "Open.
11.)Click the "OK" until all printer windows are closed.
Figure 8-192 Printer set restore
Figure 8-193 Printer set restore

GE LOGIQ P6 Specifications

General

Type	Ultrasound System
Connectivity	DICOM, USB, Ethernet
Applications	Obstetrics, Gynecology, Vascular, Cardiology, Musculoskeletal
Probes	Convex, Linear, Phased Array
Imaging Modes	B-mode, M-Mode, Color Doppler, Power Doppler, Pulsed Wave Doppler
Portability	Mobile
Transducer Ports	3 active ports