GE HEALTHCARE
DIRECTION 5245279, REVISION 3 LOGIQ™ P6/P6 PRO SERVICE MANUAL
8 - 146 Section 8-4 - Software Installation
8-6-2-1 Perform Software Reloading in the Service Platform (cont’d)
9.) Select “Reload System Software”
10.)Verify that "Local Archive" is available under Dataflow.
11.)Press “ReLoad”.
12.)Confirmation message pops up.
13.)Press “Yes” to proceed.
14.)Progress bar is displayed
Figure 8-218 Reload system Software
Figure 8-219 Reloading setup in progress
To Next Page
Loading...
