GE SEER 1000 - Event Button LED; Hookup Guidance LED

Product Overview
34 SEER™ 1000 2067634-077 Revision B
Event Button LED
This two-color LED indicates the following recorder statuses:
Recorder Status
Status Indicator Light
Ready for recording
Solid green
Recording in process
Intermittent flashing green
Event marked (by pressing Event
Button)
Green, then fades
Contains recording
Solid yellow
Low battery
Slow flashing yellow
Service needed
(Refer to the section “How to Notify
Service if the Recorder is Defective”
on page 90 for more information.)
Fast flashing, green and yellow al-
ternating
Hookup Guidance LED
Prior to recording, this two-color LED indicates the following hookup sta-
tuses:
Hookup Status
Hookup Guidance Light
Electrodes properly connected
Solid green
Electrodes loose
(excluding ground electrode)
Flashing yellow
Recording in process
LED is turned off
Service needed
(Refer to the section “How to Notify
Service if the Recorder is Defective”
on page 90 for more information.)
Fast flashing, green and yellow al-
ternating