GE SEER 1000 - Bluetooth Troubleshooting

Troubleshooting
2067634-077 Revision B SEER™ 1000 89
Message
Recommendation
“Wrong password.”
The password is wrong. Try a valid pass-
word.
“Wrong technician or password.”
The technician ID does not exist or the
password is wrong. Try a valid combina-
tion of technician ID and password.
Bluetooth Troubleshooting
Trouble Indicators
Cause
Recommendation
Error while connecting
recorder and app
Recorder and app device are
either too close to or too far
away from each other.
For best results, do not position
the devices closer than 50 cm
(approx. 20 inches) to each
other or more than 10 m (ap-
prox. 11 yards) from each
other.
The app device's Bluetooth
connectivity is not enabled.
Verify that your device's Blue-
tooth connectivity is enabled.
Objects between recorder
and application device affect
the connection.
Remove any objects from the
line of sight between recorder
and application device.
RF interfering devices affect
the connection.
Remove any possible RF interfer-
ing devices from the vicinity of re-
corder and application device.
After starting a record-
ing, no wireless connec-
tivity active
The recorder's Bluetooth
connectivity is not enabled
because this is switched off
after the start of a recording.
Press and hold the Event But-
ton for approx. 3 seconds until
the multi-beep indicates wire-
less connectivity is activated.