Using the Apple iOS App
2067634-077 Revision B SEER™ 1000 63
Add or Select a Patient
1. To add a new patient, touch Add Patient.
2. Enter the patient demographic data in the Add Patient window.
You have to enter at least the Patient ID.
3. Touch the Continue button.
Find Device
After selecting a patient, you will be taken to the Find Device screen.
1. If the recorder is not turned on, press the Event Button until you
hear a beep to switch on the recorder.
2. Touch Find Device.
The recorder identifier will appear in the Select An Accessory
window.
NOTE
The time it takes to find a device can vary from a few sec-
onds to several minutes depending on the number of Blue-
tooth devices in the area and on other electronic conditions.
3. Touch the identifier to select the recorder.
To Next Page
Loading...
