Using the Microsoft Windows App
2067634-077 Revision B SEER™ 1000 77
4. If the patient has been previously entered into the app, double-
click the patient name or click the patient entry and then the V
symbol.
5. Press the Event Button to switch on the recorder.
6. Click the M symbol to start the device search.
NOTE
The time it takes to find a device can vary from a few sec-
onds to several minutes depending on the number of Blue-
tooth devices in the area and on other electronic conditions.
7. Click Cancel after the message Searching for new device has
changed to (Number) new device(s) found.
8. Double-click the recorder or click the recorder entry and then the
V symbol.
When first connecting to a device, you will either be asked to en-
ter the PIN code 1234 or to confirm the PIN code displayed in or-
der to enable a Bluetooth connection to this device.
Refer to the “Electrode Placement and Waveform Preview” section on
page 78 for next steps.
To Next Page
Loading...
