GEDA PH 650 - Monitoring Locking of the Assembly Crane

GEDA
®
Temporary Construction Hoist PH 650
Operating Manual Page 61 of 64 BL148GB2017 / 11
13.2.4 Monitoring locking of the assembly crane
During travel, the assembly crane must not swing into the path of travel
(mast). Thus, this must be locked in a secure position.

The locking bolts (1) removed interrupt the safety circuit and the car
will not move.
 Push the locking bolts (1)
towards the bracket and lock.

The locking bolts (1) must be removed if no assembly crane is
installed.
1