Geeetech A30 User Manual

45
Note:
 If you choose a Wi-Fi hotspot without password, click ―Next‖ and continue your
setting from step7.
 During the above config process, your Phone is connected to the GT-printer wifi
hotspot, which has no access to the internet connection. So you will be logged out.
After your successful config., your phone will be connected to your previous
network automatically. If not, please connect it manually and log in to EasyPrint 3D
again.
 If you are asked to switch the network during the wifi config, please choose NO to
stay with the GT-printer wi-Fi network, as shown in the following picture.

Geeetech A30 Specifications

General

Build Volume	320 x 320 x 420 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Connectivity	USB, SD card
Frame Material	Aluminum
Printing Technology	FDM (Fused Deposition Modeling)
Heated Bed	Yes
Supported Filaments	PLA, ABS, PETG
Display	LCD
Power Supply	24V
Bed Temperature	Up to 110°C
Nozzle Temperature	Up to 250°C
Printing Platform	Removable glass platform