SHENZHEN GETECH TECHNOLOGY CO,.LTD
If the moving direction is reverse, you can alter the direction in the firmware. Please refer to FAQ.
Tips: In manual control, the high-light part of the panel stands for the current selected direction, and it
moves 1mm every click. You can also choose to move 10mm or 50mm every click, but here we choose 1mm
in order to avoid possible incorrect operation.
5.1.2 Heating Test
Click the heating button of the hot bed and the extruder . When the slash disappeared as
shown below, it indicates the heating is ongoing and you can see the value rise up.
To Next Page
Loading...
