Rev. 00 04/19
OptiCenter OC06 Maintenance / Repairs
75
24.
– The fresh powder pump is cleaned, the powder is transported to
the after filter
25. The process is complete when this screen is displayed:
Any individual step can be repeated as needed by pressing the
corresponding key again.
– Only the selected cleaning step is carried out.
26. Visually check the inside of the OptiSpeeder, if necessary clean with
compressed air gun
27. Booth cleaning can now be started: Activate the corresponding
command on the MagicControl control unit
28. Clean the OptiCenter
29. Open the monocyclone
To Next Page
Loading...
