AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 53
Installing navigation hardware when using the Navigator box
If you are installing an older version of the LPR Processing Unit, the navigation hardware is not
included on the unit. If you require precise odometry to accurately georeference license plate reads,
you must install an external Navigator box in the vehicle. When combined with pulse odometry from
a Magneto kit or the vehicle's VSS, the AutoVu system can accurately georeference license plate
reads and track the vehicle's route.
To install navigation hardware when using the Navigator box:
1 Install Patroller on the in-vehicle computer.
For information about installing Patroller, see the Patroller Administrator Guide.
2 Install the satellite navigation hardware.
3 Install the magneto kit or connect to the vehicle's VSS signal.
4 Install wheel imaging cameras (optional).
5 Install the external Navigator box.
6 Configure external Navigator box GPS settings in Patroller. For more information, refer to the
Patroller Administrator Guide.
Example
Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the
available languages.
Installing navigation hardware when using an external USB GPS
For Patroller vehicles that do not include wheel imaging cameras, if a GPS source is not already
available in the vehicle, you can install the basic USB GPS antenna.
To install navigation hardware when using an external USB GPS:
1 Install Patroller on the in-vehicle computer.
For information about installing Patroller, see the Patroller Administrator Guide.
2 Install the satellite navigation hardware.
3 Configure Patroller GPS settings for an external USB GPS. For information, see the Patroller
Administrator Guide.
To Next Page
Loading...