AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 72
Completing the SharpX mobile installation
Before you replace the body liners and other paneling in the vehicle, ensure that the installation does
not affect the vehicle's operation or mandated safety functions or circuits.
What you should know
For software installation and configuration instructions, refer to the Sharp Administrator Guide and
Patroller Administrator Guide.
To complete the installation:
1 Test the system to ensure that the hardware is functional and the wiring is correct and solid.
2 Test network communication.
3 Test the following vehicle functions:
• GPS signal
• Odometry
• Reverse signal
• Ignition
After you finish
When the AutoVu installation is finished, include the following information in the field report that is
submitted to Genetec:
• Power connection locations
• Signal connection locations (ignition, odometer, GPS, etc.)
• Diagram the how the wires are routed in the vehicle
• IP addresses of all installed equipment
• Serial number and part numbers of all installed equipment
• Point of contact information for the customer:
• Name
• Title
• Phone number and/or email
• A read report to evaluate the performance.
To Next Page
Loading...