Network settings
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 87
Default IP addresses of LPR Processing Units
All SharpX LPR Processing Units have several internal components. Each component has a factory-
assigned static IP address.
The following table shows the default IP addresses of each of these components.
Component Default IP address
Single Board Computer 1 (SBC1) 192.168.10.1
Single Board Computer 2 (SBC2) 192.168.10.2
Genetec Video Processor 1 (GVP1) Reserved
Genetec Video Processor 2 (GVP2) Reserved
Camera Unit 1 (CAMU1) 192.168.10.5
Camera Unit 2 (CAMU2) 192.168.10.6
Processing Unit Management Controller (MPU) 192.168.10.7
Camera Unit 3 (CAMU3)
1
192.168.10.8
Camera Unit 4 (CAMU4)
1
192.168.10.9
Navigation (NAV)
2
192.168.10.10
1
For SharpX X2S with four camera ports.
2
The "NAV" IP address only applies to LPR Processing Units that include the AutoVu Navigation
Option.
To Next Page
Loading...