Restarting SharpX cameras
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 89
Restarting SharpX cameras
Certain configuration procedures require you to restart the SharpX camera. You can do this from the
Sharp Portal.
To restart the SharpX:
1 Log on to the Sharp Portal.
2 Go to the Status page.
3 Click Reboot unit, and then click OK to confirm.
The connection to the Sharp Portal is momentarily lost.
4 Wait a few minutes to allow the SharpX to restart, then refresh the browser window to log on
again.
To Next Page
Loading...