Need help?Do you have a question about the Genetec AutoVu SharpX Mobile and is the answer not in the manual?
Details the various hardware components used in SharpX mobile installations.
Covers preparation, mounting, cabling, connecting, and testing the SharpX system.
Guides for installing wheel imaging cameras, navigation hardware, and magneto coils.
Scenarios and steps for properly aligning Sharp and SharpX cameras for accurate plate reading.
Final checks, vehicle function tests, and field report procedures for SharpX mobile installation.
Explains the behavior of PWR, STAT 1, STAT 2, and FAULT LEDs on the LPR Processing Unit.
Describes the amber (Data) and green (Link) LEDs for camera data-link status.
Details the LED indicators on the SharpX camera unit for various system states.
Steps to resolve issues with network communication and Patroller ports.
Provides field of view specifications for various SharpX camera lens types.
Lists the factory-assigned static IP addresses for LPR Processing Unit components.
Procedure to restart the SharpX camera via the Sharp Portal.
Instructions for terminating or shortening CAT5e cables using a crimp tool.
Steps to access and log into the Sharp Portal for camera configuration.
Details FCC and Canadian ICES-003 compliance for AutoVu Sharp systems.
General| Category | Automobile Accessories |
|---|---|
| Image Sensor | CMOS |
| Power Supply | 12-24 VDC |
| Ingress Protection | IP67 |
| Type | License Plate Recognition Camera |
| Field of View | 40° |
| Operating Temperature | -30°C to 70°C |
| Connectivity | Ethernet, Wi-Fi |
| Mounting | Vehicle mounted |
| Dimensions | 150 mm x 100 mm |
| Compatibility | Compatible with Genetec AutoVu software |
To Next Page