tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 1
1
AutoVu SharpX mobile installation
This section includes the following topics:
• "Hardware components for SharpX mobile installation" on page 2
• "Hardware components for SharpX mobile installation with external Navigator box" on
page 5
• "Preparing to install SharpX mobile hardware " on page 7
• "Installing SharpX mobile hardware" on page 9
• "Connecting SharpX systems in a test environment" on page 10
• "About mounting the LPR Processing Unit" on page 11
• "Cable Tester overview" on page 14
• "About mounting the SharpX camera for a mobile installation" on page 18
• "Installing the SharpX using the hardmount bracket" on page 19
• "Installing the SharpX using the magmount" on page 24
• "Camera cabling do's and dont's" on page 26
• "Drilling the camera cable holes" on page 27
• "Selecting the camera ports for the LPR Processing Unit " on page 28
• "Securing wires using tension clamp connectors" on page 31
• "Connecting SharpX cameras for a mobile installation" on page 33
• "About installing wheel imaging cameras in a mobile AutoVu system" on page 43
• "About AutoVu satellite hardware" on page 51
• "Guidelines for installing the in-vehicle computer" on page 64
• "Alignment scenarios for Sharp and SharpX cameras" on page 65
• "Overview of aligning SharpX cameras" on page 67
• "Sealing the camera cable holes " on page 71
• "Completing the SharpX mobile installation" on page 72
To Next Page
Loading...