AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 18
About mounting the SharpX camera for a mobile
installation
In a mobile installation, SharpX cameras can be attached to the roof of the vehicle using the Genetec
pan/tilt/roll bracket in conjunction with either the Genetec hardmount or magmount. In addition, a
variety of mounting brackets are available to attach the camera directly to the vehicle's light bar.
IMPORTANT: The warranty is void if you open or drill holes in the AutoVu equipment, or if you add
decals and other adhesive materials, or paint SharpX cameras.
IMPORTANT: Do not bring the camera unit through a contact car wash with brushes that scrub the
vehicle. The brush cords can get stuck in mechanical parts and on the cable connector. Use only non-
contact car washes with water jets.
To Next Page
Loading...