Genetec AutoVu SharpX Mobile - Additional Resources and Appendices; Camera Lens Field of View

Troubleshooting for SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 76
State Description PWR STAT 1 STAT 2 FAULT
Ongoing
Firmware
Update
The LPR Processing
Unit is being
updated and it
will reset after
completion
(normally 10~20
seconds, max 5
min).
On Fast blinking Off Off
IPConfig Factory
Reset
Immediately after
power up with the
config reset button
pressed, the IP
configuration is
reset to factory
values. All LEDs
flash 5 times in one
second.
See
description
See
description
See
description
See
description