Genetec AutoVu SharpX Mobile - Page 85

Troubleshooting for SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016 79
State Description LED (red/green)
Firmware update request The camera unit firmware
update is beginning shortly.
The unit will restart after
completion (five minutes max).
Green steady On
Toggles Red three times
Ongoing Firmware Update The camera unit is being
updated and it will reset after
completion (normally 10~20
seconds, max 5 min).
Blinks green rapidly (e.g., 10 per
second)