The GV-Video Server can connect up to two GV-Video Gateway / GV-Recording Server.
To send the video images to the GV-Video Gateway or GV-Recording Server, follow the
steps below.
1. Activate Link: Enable the connection to GV-Video Gateway / GV-Recording Server.
2. Host Name or IP Address: Type the host name or IP address of GV-Video Gateway /
GV-Recording Server.
3. Port Number: Match the communication port on GV-Video Gateway / GV-Recording
Server. Or keep the default value 50000.
4. User Name: Type a valid user name to log into GV-Video Gateway / GV-Recording
Server.
5. Password: Type a valid password to log into GV-Video Gateway / GV-Recording
Server.
6. Enable schedule mode: Enable the GV-Video Gateway / GV-Recording Server
connection on the schedule you set in the Select Schedule Time section. Refer to 4.5
Recording Schedule for the same settings.
7. Click Apply. The Connection Status should display “Connected” and connected time.
8. To establish the connection to the second GV-Video Gateway / GV-Recording Server,
click the Connection 2 tab and repeat above steps for setup.
68
To Next Page
Loading...
Need help?
General
