Introduction
1–4
TECHNICAL DATA
The water-saver should not be used with a sterilizer with Sealing Flange—
for example, those installed in an area that may process Bio Hazard
material or Bio-contaminated waste. If installed in a sterilizer of this type, the
water-saver could become a breeding ground for bioburden, which would
then be constantly recirculated through the system. Additionally,
decontaminating the components would be difficult at best.
The dimensions and weight, utilities requirements, and electrical supply for
the water-saver are listed on installation drawing HS3472, included in the
water-saver package.
The capacity of the reservoir tank is approximately 6 gallons (22.7 liters).
NOTE
To Next Page
Loading...
