Getinge MP-129 Series - Section 4 Maintenance and Troubleshooting; Periodic Maintenance Schedule

350545 4–1
Section 4 Maintenance and
Troubleshooting
PERIODIC MAINTENANCE SCHEDULE
Maintenance should be performed by qualified personnel
ONLY.
Provide preventive maintenance for the water-saver at the intervals
specified.
If an MP-129A Water-Saver is installed on a 400 /500 Series sterilizer, follow
the pressure switch adjustment procedure on drawing SK48835.
Table 4–1. Periodic Maintenance Schedule
MAINTENANCE ITEM
RECOMMENDED
INTERVAL
FOR DETAILS,
SEE PAGE
Check the operation of water-saver
components as part of the periodic
maintenance of the sterilizer.
WHEN REQUIRED Refer to the
Periodic
Maintenance
Schedule in the
Service Manual
for your
sterilizer.
Clean and sanitize the tank. WHEN REQUIRED 4-2
Check the operation of the
temperature switch
EVERY
THREE MONTHS
4-3
Check the operation of the
pressure switch. To adjust, use the
proper procedure for your model
sterilizer:
• 100 and 200 Series
• M/C 3500 and 3600
• M/C 4233
EVERY
THREE MONTHS
See Note below.
4-4
4-5
4-6
WARNING
NOTE
PERFORMANCE
ASSURANCE PLAN
Preventive maintenance
performed by factory-trained
service representatives, using
authorized parts and service
techniques, is recommended.
Recognizing symptoms of
potential trouble and making
corrections immediately is less
costly and time consuming
than repairing damaged
equipment. Our Performance
Assurance Plan offers scientific
maintenance, not merely repair
service.
For quality service on this
equipment and information on
our Performance Assurance
Plan, contact Getinge USA,
Inc. 1777 East Henrietta Road,
Rochester, NY 14623-3133 or
call
1-800-950-9912.